qizhen0926
Guest
|
Floor direct impact on the quality of living houses and overall appearance. So the inspection room, the floor is full acceptance fitting room acceptance process is an important part. Fully furnished room wooden floor "common" are: color, from the dark, deformed, there was a noise, and moth eyes, cracks, scratches, etc. When the level of bias and walking stampede. Home Inspector Description: Currently renovated room floor is quite conspicuous.
Acceptance depends on the color of wood flooring first floor are the same. If the color is too large, directly affect the appearance, you can ask exchange; if the color is too uniform, almost no color, it depends on the pattern of the surface of the floor if the same. If the pattern is almost the same, then there may be wood craft, rather than the so-called rare species of wood flooring material. Now some flooring supplier, a generic timber flooring material, but in the surface layer of paste veneer valuable wood species to shoddy and negative with aluminum foil and paste it, saying it was to moisture, in fact, is the fear of being seen negative and positive patterns are inconsistent. Second floor to see if there is sound, acceptance on the floor back and forth, the pace should be increased, especially in parts of the wall openings and pay more attention to the site inspection, found the sound portion, to repeat the move, to determine the specific location of the sound, and marked.
In that case, you can request removal of resurfacing. There are sounds of the site, construction workers are in the construction process, operation and use of non-standard materials caused by unqualified. Operating mainly in the non-standard keel is not firmly fixed; material failure is mainly reflected in the keel without drying. Some construction keel with decoration and construction unit without drying, the surface has dried traces, in fact, did not do. Specification decorative wood products moisture content should be controlled at about 12%. High moisture content of the keel, the natural drying process of timber volume will be reduced, resulting in loose. Once again, acceptance of the floor deformation, warping, acceptance method is to use two meters long ruler, against the floor flatness should not be greater than 3 mm. Pumping a few more measurements, if the passing rate of 80% or more considered as eligible, on the contrary, that is unacceptable.
Sometimes we find local bagging floor: If the floor is wood, it is because the shop floor is too tight or too dry (moisture content is too low); if it is laminate flooring, it is poor quality of the floor. So bagging floor is a serious quality problems.
Finally, there is acceptance of the floor surface is moth eyes, cracks, scratches. Common is due to keel untreated, there are worms. Moth eye, etc. When found, the floor has been almost a bore; cracks and scratches to see that. Specification: floor gap should not exceed 0.5 mm; the decoration is mainly caused by rough scratch, as with waxing method still can not be repaired, it must be replaced.
all link:
plastic tongue and groove
decking materials composite home depot
hard plastic wood deck
|
Sponsored by: The Fans!
Home
Help
Search
Members
Chat
Member Map
Login
Register
Reply
Add Poll
Notify of replies
Send Topic
Print